Flat Roof Repair & TPO Roofing in Eagle Pass, TX

Our Flat Roof Repair Process

1. Leak tracing: we find the true entry point, which is often a seam, drain or curb rather than the spot above the ceiling stain.
2. Moisture check: we look for wet insulation under the membrane, which determines whether a repair or replacement is needed.
3. Repair: seams are welded or re-sealed, punctures patched and flashing rebuilt at walls, curbs and penetrations.
4. Drainage: drains, scuppers and gutters are cleared, and ponding areas are addressed.
5. Protection: where appropriate, a reflective coating extends the life of a sound roof.

Why TPO Works Well in South Texas

TPO is a white single-ply membrane with heat-welded seams. Its reflective surface bounces back much of the sun’s energy, keeping the building below cooler and reducing cooling load, a major advantage in Eagle Pass summers. Welded seams are stronger than glued seams, and TPO resists punctures, UV and common rooftop chemicals.

For many commercial buildings, warehouses and home additions with low-slope roofs, TPO offers the best balance of durability, energy efficiency and value.

Flat Roof Maintenance Checklist

• Clear drains, scuppers and gutters every season
• Remove debris and branches after storms
• Watch for water standing longer than 48 hours
• Check seams and flashing around HVAC units
• Look for blisters, cracks or bare spots in coatings
• Schedule inspections in spring and fall

Flat Roofs on Homes, Carports & Additions

Flat roofs are not just for commercial buildings. Many Eagle Pass homes have low-slope sections over patios, carports, porches and room additions, and these are frequent leak spots where the flat section meets the main roof. We repair and replace these residential flat roofs with the same materials and care we use on commercial jobs.